Windsor Clikstix Alphabet Cutters FULL Set - SMALL for Cupcakes (Upper, Lower & Numbers)
Clikstix Alphabet Cutters FULL Set - SMALL (Upper, Lower & Numbers)
The full set of the Clikstix SMALL alphabet & numbers cutters from Windsor CakeCraft contains all three sets of cutters: upper case, lower case and numerals at a special discount price. The small set is smaller than other cutters in the Clikstix range and is the perfect size for cupcakes and other small inscriptions.
The lower case letters include a - z and the ampersand (&)
The Upper case (CAPITAL) letters include A - Z and the ampersand (&)
The numeral cutter set includes numbers from 0-9
All are in a fabulous small font, all on strips with fitted plunger ejector - Much less likely to get lost than separate cutters!
These cutters are made from food safe plastic and the approximate letter Size: 13mm - 18mm high. The overall length of each strip is approx 23cm (230mm). The cutter comes in hygienic retail packaging complete with full instructions.
Why not look at the other fabulous cutters in the Clikstix range!
Or compare all the alphabet and number cutters available at Partyanimalonline.
Instructions and Tips for Use
Clikstix alphabet and number cutters are useful for all sorts of cake decorations, plaques and other sugarcraft projects, and are wonderful on Cupcakes!
If you have ever struggled with getting paste out of your cutters this is the product for you (even if you haven't it's a great and easy cutter to use). Because each cutter has its own built in ejector you will never have to dig out those fiddly bits of paste again.
Simply roll out your paste to about 1-2mm thick on a non-stick board. Use a little icing sugar or cornflour to prevent sticking. Press the Clikstix down firmly - make sure you only hold the sides and do not press the ejector at this point or it will flatten the letter before you have cut it out. Give the cutter a bit of a scrub on your board to make sure the paste is completely cut through.
Lift the cutter with the shapes still in (if one or two fall out - no problem ...it saves the ejection!) and then press down on the ejector to let the cut shapes drop out. Quick and simple but it does take a bit of practice to get your paste thickness right.
We recommend you use either SFP Flower Paste or Modelling Gum Paste as ordinary sugarpaste tends to stick. You can also use up to a 50:50 mix of gumpaste to sugarpaste.