FMM Tappits Cutters HEARTS / CHERUBS

FMM

£3.89 

Share:

Hearts and Cherubs Tappit Cutter From FMM


FMM Tappits Range – HEARTS AND CHERUBS set From leading manufacter FMM. The cutter set includes 10 assorted heart and cherub themed shapes.

Made from food-safe plastic this set contains cutters for;

Hearts & Cherubs -
Trumpet-blowing Angel-45mm x 25mm
Winged Cherub-42mm x 30mm
Heart-shaped Key-45mm x 23mm
Cupid Cherub with bow and arrow-40mm x 30mm
Heart tummy Teddy bear-35mm x 27mm
Two Hearts joined with arrow-38mm x 23mm
Scallop-edged heart- 40mm x 30mm
Shooting Star-40mm x 20mm
Heart with Rose inside-33mm x 30mm
Big Star-35mm x 29mm

  

Instructions and Tips for Use


This Tappit set contains absolutely classic designs you will use again and again!

Great for romantic cakes including Valentines engagement, wedding and anniversary...or just to say 'I love you'!

This fantastic range of cutters from FMM are very versatile and simple to use.

Lightly grease a non-stick board with Trex or other white fat or shortening and roll out Mexican paste very thinly. (Other pastes may be used but I find Mexican to be the best as it doesn't stretch too much, can be rolled thinly and doesn't dry out too quickly)
Very lightly dust the top surface of your paste with Cornflour (cornstarch) a tip here is to put the flour into a muslin cloth and simply wipe across the top surface - that way you don't get too much onto the paste.
Press the tappit set firmly onto the paste ensuring that you press all areas of the cutter. 'Flick' the cutter off the paste by placing a fingernail under one end and lifting rapidly. The paste should remain on the board. Carefully peel away the excess paste leaving your required letters or shapes.
Lift the cut shapes with a palette knife and fix in position with a little edible glue.
As with Patchwork cutters the paste can be coloured before cutting out, painted or dusted with lustre colours before fixing in position.
You may need to practice a little to get the thickness of the rolled paste just right - it needs to be thin enough the cut through but be thick enough to allow the detail on the cutters to show.